LeddarTech LeddarVu8

The LeddarTech LeddarVu8 is a long range (185m) lidar which provides 8 individual distances within a 16deg to 99deg field of view depending upon the model used. ArduPilot always uses the shortest of the 8 distances provided.


Support for this sensor was released with Copter-4.0.4

Connecting to the Autopilot

Any of the autopilot’s spare serial ports may be used. The diagram below shows how to connect the sensor’s TX, RX and GND pins assuming Serial2 is used.


The lidar must be powered separately with a stable 12V source. During testing the lidar was unable to reliably provide distances if the voltage dropped below 11V.

The following parameters should be set

If you instead were using the Serial4 port on the autopilot then you would set SERIAL4_PROTOCOL = 9, and SERIAL4_BAUD to 115

Testing the sensor

Distances read by the sensor can be seen in the Mission Planner’s Flight Data screen’s Status tab. Look closely for “sonarrange”.