This hardware comes preflashed with a RadioLink-branded version of ArduCopter and an ArduPilot-compatible bootloader. To use non-branded ChibiOS-based ArduPilot firmware versions, download the required vehicle firmware .apj file from https://firmware.ardupilot.org/ and flash your board using MissionPlanner’s “custom firmware” option.
In case a bootloader re-installation is required, you can boot your board to DFU-mode using the following solder-points:
Then follow the instructions on how to load firmare onto ChibiOS boards.
The flightcontroller’s plastic case shows the telemetry ports’ numbers reversed compared to the board’s PCB imprints and the
firmware’s SERIALn assignments, this requires additional attention!
MiniPix voltage and current sensing pins use Pixhawk standard ( BATT_VOLT_PIN = 2, BATT_CURR_PIN = 3).
The additional ADC pin can be used for either RSSI or analog airspeed. Set required option to PIN = 11.