Echologger ECT400 echosounder

The EchoLogger ECT400 is an echosounder (aka underwater sonar) with a 100m range, 5 degree beam width and 1hz ~ 10hz update rate. More details can be found in the datasheet


image courtesy of


Support for this sensor was added to Rover-3.4.

Connecting and Configuring

The ECT400 provides distance measurements using the NMEA protocol over serial at 115200 baud.

The sensor can be connected to any available serial/uart port on the autopilot. In the diagram below the first sensor is connected to SERIAL2.


If the SERIAL2 is used then the following parameters should be set:

Then the following range finder related parameters should be set:

Configuring the sensor

By default the sensor comes configured to sample the depth at only 1hz and to a maximum depth of 10m.

Using a USB to RS232 converter connect to the sensor from your PC using a terminal program like Putty (Connection type of “Serial”, Speed of “115200” and Serial line of the appropriate COM port).

If connected properly NMEA data should appear on the console. Type:

#help           (to display the help menu)
#range 100000   (to set the range to 100m)
#interval 0.5   (to set update rate to 2hz)
#nmeadpt 0      (to disable dpt message)
#nmeamtw 0      (to disable mtw message)
#nmeaxdr 0      (to disable xdr message)
#nmeaema 0      (to disable ema message

More info on NMEA message contents can be found here

Testing the sensor

Distances read by the sensor can be seen in the Mission Planner’s Flight Data screen’s Status tab. Look closely for “sonarrange”.