The Hexsoon EDU450 is a relatively low cost frame including motors, ESCs and propellers
Connection and Setup¶
- Connect the four ESC wires to the back of the autopilot as shown in the QuadX configuration
- Mount the GPS/compass unit on the front of the frame slight elevated if possible to increase the distance between the ESC wires
Firmware used: Copter-4.0
Parameter file: hexsoon-edu450.param
This parameter file can also be loaded using the Mission Planner’s Config/Tuning >> Full Parameter Tree page by selecting “hexsoon-edu450” from the drop down on the middle right and then push the “Load Presaved” button.